n1 exhaust piping too low
- Thread starter Cholob
- Start date
- Staff
- #2
- 52,105
- 22,314
How low are you?
- Thread starter
- #3
arnd 2-2.5 inch? Not slammed.
- Thread starter
- #5
- Staff
- #7
- Staff
- #8
- 52,105
- 22,314
I'd send that pic to invidia to ask what they think. I know others have the exhaust, but I've yet to hear anyone talk about scraping. Seems way low....even though you're lowered.
- Thread starter
- #9
yea i unno why they made it so low.i heard bending the hangers wud lift it up, but stil trying to find other options.
Michal006
Well-Known Member
@Dennis Rockholt you have N1? Is your exhaust also sit that low?
Dennis Rockholt
9k Alll Day
.
No my N1 is not that low, try flipping it around so the tri-bolt has this type of design. You cannot see the pipe under my car unless you actually get under it. Ill take a pic tomorrow >> . .
No my N1 is not that low, try flipping it around so the tri-bolt has this type of design. You cannot see the pipe under my car unless you actually get under it. Ill take a pic tomorrow >> . .
derekfriedrice
Well-Known Member
That's how my N1 sits, I'm probably going to take it to a muffler shop and try to have them raise it up
Dennis Rockholt
9k Alll Day
Maybe the N1 for the '14 is different. Mine does not look like that, I will take a picture on lunch
Kevv_Si
Well-Known Member
my n1 sits that low aswelll.....scrapes on every big speed bump (if i did go over them)
derekfriedrice
Well-Known Member
Well technically mine is 2012+ N1 lol, but I only scrape on giant dips/speed bumps also
jhuerto23
Well-Known Member
mine sits hella low also... I have a sedan 2012 si.. Anybodu have a fix for this?
ErlDzn_FB6
Well-Known Member
- 8
- 0
Has anyone found a solution to this? I was going to buy the 70mm N1 and now after finding out it scrapes I'm not sure if i should. I have a 2014 si sedan with h&r springs.
I have the tsudo catback for my 2012 si sedan and it sags just like that, not as much but close. I took it to muffler shops and they tried to weld it back up from the hangars but it didn't move very far. You could try flipping the tri design mid pipe but you might hit other things. I had a shop tell me they can cut the pipe completely and re-weld it up but that might cost a lot. They are heavier than stock i believe so that could be another reason these big exhausts sag, full race, invidia, tsudo.
derekfriedrice
Well-Known Member
Just scrape it till it doesn't scrape anymore like I did 
ErlDzn_FB6
Well-Known Member
- 8
- 0
