Intrepid
Well-Known Member
Purchased a roof visor for my 2012 Civic Si Coupe
Honda Part Number # 08R01-TS8-300
Installation is extremely easy and i would rate it as a 1/10 in difficulty.
I didn't take any photo's of the process of installing it but i will describe it the best i can.
Basically it comes in the box with a bag of (4)screws and (4)clips and (4) Pieces of clear tape.
The instructions that come with the roof visor tell you where to measure and place the clear tape, but that seemed a bit too hard for me to follow so basically what i did was put the screws and clips in place on the car and then removed them and put the clear tape in those spots where the clips would be. All the tape is is a layer of protection between the paint and the clip so that the clip doesn't scratch the finish.
Once the tape is in place you can set the visor back on teh roof and hook the clips in and tighten them down.
Here are a few pics of it installed on the car
Side profile of car with roof visor:
Side Profile of Roof VIsor:
Front Profile of Visor:
Rear View of the roof visor:
Side Profile of the clips that hold the visor to the roof:
I found this to be a very easy addition to the car, and if you wanted to remove it later it would be very easy to do. Hope this helps any of you out who are thinking about purchasing one
Honda Part Number # 08R01-TS8-300
Installation is extremely easy and i would rate it as a 1/10 in difficulty.
I didn't take any photo's of the process of installing it but i will describe it the best i can.
Basically it comes in the box with a bag of (4)screws and (4)clips and (4) Pieces of clear tape.
The instructions that come with the roof visor tell you where to measure and place the clear tape, but that seemed a bit too hard for me to follow so basically what i did was put the screws and clips in place on the car and then removed them and put the clear tape in those spots where the clips would be. All the tape is is a layer of protection between the paint and the clip so that the clip doesn't scratch the finish.
Once the tape is in place you can set the visor back on teh roof and hook the clips in and tighten them down.
Here are a few pics of it installed on the car
Side profile of car with roof visor:
Side Profile of Roof VIsor:
Front Profile of Visor:
Rear View of the roof visor:
Side Profile of the clips that hold the visor to the roof:
I found this to be a very easy addition to the car, and if you wanted to remove it later it would be very easy to do. Hope this helps any of you out who are thinking about purchasing one
