stormtrooper
Well-Known Member
- 252
- 161
So after I listened to a few other people on how to remove the front Si badge, I figured I'd post a DIY for everybody. Here is the set of tools you will need:
Flathead Screwdriver
Allen Wrench (3/16 standard or 5 metric)
Phillips head screwdriver nut (detachable)
When you open your hood this is what its going to look like (After Si badge is removed):
The two bolts inside the two rectangle shafts your will need an allen wrench for.
The rest of the clips you can use a flat head screwdriver with. Lift up the inner circle first then lift up the outer circle.
The two rubber grommets on the top center you can remove with just your hand. But you will need a flat head screwdriver to re install them.
After you have the 2 allen wrench bolts, 2 rubber grommets and the 8 clips you can now remove the plastic cover. It will require a little finesse to angle the plastic piece out from under the front grill and out of the hood latch.
After you remove it just place it to the side with the rest of the pieces so you don't loose any thing.
Flathead Screwdriver
Allen Wrench (3/16 standard or 5 metric)
Phillips head screwdriver nut (detachable)
When you open your hood this is what its going to look like (After Si badge is removed):
The two bolts inside the two rectangle shafts your will need an allen wrench for.
The rest of the clips you can use a flat head screwdriver with. Lift up the inner circle first then lift up the outer circle.
The two rubber grommets on the top center you can remove with just your hand. But you will need a flat head screwdriver to re install them.
After you have the 2 allen wrench bolts, 2 rubber grommets and the 8 clips you can now remove the plastic cover. It will require a little finesse to angle the plastic piece out from under the front grill and out of the hood latch.
After you remove it just place it to the side with the rest of the pieces so you don't loose any thing.
