custom exhsust?

Michael Perez

Well-Known Member
556
154
Miami, FL
Vehicle Model
2012 Civic Si
Body Style
Sedan
Hello. I have someone that does custom work and I was wondering how to go about center exhaust. Do they have a blank valance or would I need an LX bumper and cut it?
 

VNPP

Well-Known Member
987
519
Rolla, MO
Vehicle Model
Civic LX
Body Style
FG3 Coupe
If you have a black si, i would trade you my LX bumper
 

Michael Perez

Well-Known Member
556
154
Miami, FL
Vehicle Model
2012 Civic Si
Body Style
Sedan
Even if it does fit. After further researc it seems as if the heat shield and plastic is in the way if where the pipe would route to the center
 

Michael Perez

Well-Known Member
556
154
Miami, FL
Vehicle Model
2012 Civic Si
Body Style
Sedan
Well today out if boredom I removed my axle back and my car sounds sweet and deep However the car vibrates because the exhaust is being pushed in that tunnel and against the lowering spring a concern of mine is the spring and if the heat will damage it. I think tomorrow i will have a flange and turn down bolted with the existing hardware. What do u guys think?
 

Michael Perez

Well-Known Member
556
154
Miami, FL
Vehicle Model
2012 Civic Si
Body Style
Sedan
As of now the car has no tip and axle back. Tomorrow morning I am heading out to explore my options and will post pics
 

Michael Perez

Well-Known Member
556
154
Miami, FL
Vehicle Model
2012 Civic Si
Body Style
Sedan
Essentially, however the tank is fully covered in a plastic shield and it dumps pretty far to the right hand side avoiding any potential dangers. I will have pics up this afternoon
 

Michael Perez

Well-Known Member
556
154
Miami, FL
Vehicle Model
2012 Civic Si
Body Style
Sedan
I will try asap to get vids up. The exhaust is stock except for tg axle back. So I only have one muffler
 
Top