pins for ECU

[Flippercon]

I know ive seen quite a few people with gauges installed. What pins were used to install wideband and other gauges . It would be the smaller of the 2 used in the connectors.

 

[webby]

I know @Sleepingpanda has one

 

[Sleepingpanda]

I never hooked it up to the ecu. Youre asking for pin part numbers? Meh. If I was that serious I'd spend the 150-170 for a new engine harness. And just make my own pigtail from one of the ecu pins.

Probably a lot easier than trying to source a pin and tooling.

 

[Flippercon]

I never looked to see if there is a pin in place. I will find out Friday. I will update this post when i find out.

 

[Sleepingpanda]

I never looked to see if there is a pin in place. I will find out Friday. I will update this post when i find out.

What do you mean? A pin in place where?

 

[Flippercon]

Connector A pin 34. Not sure if they left them empty or put in pins witout wires.

 

[Flippercon]

http://www.hondata.com/civic_pin_request_info.html
Imagine this is the same for 9ths. Im going to email hondata and see.

 

[Pat Mills]

Any development on the install? I'm still super confused on where to wire the Analog. Lol

 

[Flippercon]

Install is scheduled for Friday and mock up of bung placement. Actual install of pins will be when bung gets welded in.

 

[Pat Mills]

Are you turbo or sc? Any chance of a diy? At least on the wiring part?

 

[Flippercon]

Sorry im doing sc install friday. Sure i can snap some pics.