K-tuned clutch master cylinder upgrade kit

[Charles Brown]

I was looking around at various upgrades for my 13 si and came across this on axions page. was wondering if anyone here had done this upgrade and if so how do you like it?
http://stores.axionind.com/k-tuned-rsx-8th-9th-gen-civic-cmc-upgrade-kit/

 

[Sarcras]

From what I have read, the few that have done them did not notice a change.
Some say there is another delay valve in the master cylinder like in the slave and that one from ktuned would get rid of it.

 

[Charles Brown]

yes the kit is 180 which dosent seem bad but you can get the braided cable for around $45 so i may just do that still not sure yet

 

[Charles Brown]

also k-tuned makes a slave cylinder perhaps you have to replace both of them to get rid of the delay. havent found much info on them yet

 

[Sarcras]

also k-tuned makes a slave cylinder perhaps you have to replace both of them to get rid of the delay. havent found much info on them yet

Getting the slave cylinder would save a headache with taking out the delay valve in it. Not hard to do but that little "c" clip can be a royal pain to get out. Definitely get the braided clutch cable though.

 

[Sarcras]

Here is the link if you want to give the delay valve a shot and save some money on the slave cylinder.
http://9thcivic.com/forum/threads/clutch-delay-valve-removal.8624/

 

[ron v]

C clip of insanity.

 

[Charles Brown]

thanks for the advice i think im going to get the ktuned slave cylinder to save the headache, and looking at this line on axion not sure if i can use it with the ktuned slave cylinder or if it requires the ktuned cable anyone use this one?

http://stores.axionind.com/2012-honda-civic-si-2013-acura-ilx-steel-braided-clutch-line/

 

[Sarcras]

It should be fine. The fittings are going to be the same.